--- Welcome to the official ADCIRCWiki site! The site is currently under construction, with limited information. ---

For general information, see the ADCIRC site, ADCIRC FAQ, or the ADCIRC Wikipedia page. For model documentation not yet available on the wiki, see the ADCIRC site. New content is being continuously added to the ADCIRCWiki, and material from the main ADCIRC site will be gradually transitioned over to the wiki.

Fort.11 file

From ADCIRCWiki
Revision as of 13:55, 28 June 2022 by Cfulcher (talk | contribs) (Move file format to this page, initial format edits to create page sections)
Jump to navigation Jump to search

The fort.11 file is only used for a baroclinic run. Baroclinic 2DDI runs are not yet supported. Baroclinic 3D runs occur if IDEN is not equal to 0.

File Format

The basic file structure is shown below. Each line of input data is represented by a line containing the input variable name(s). Blank lines are only to enhance readability. Loops indicate multiple lines of input.

File structure for a baroclinic 2DDI run

IDEN = 1 or -1

Header Line 1
Header Line 2
NVP
for k=1 to NVP
jki,DASIGT(jki)
end k loop


IDEN = 2 or -2

Header Line 1
Header Line 2
NVP
for k=1 to NVP
'jki,DASALT(jki)
end k loop

IDEN = 3 or -3

Header Line 1
Header Line 2
NVP
for k=1 to NVP
jki,DATEMP(jki)
end k loop

IDEN = 4 or -4

Header Line 1
Header Line 2
NVP
for k=1 to NVP
jki, DATEMP(jki), DASALT(jki)
end k loop

File structure for a baroclinic 3D run

IDEN = 1 or -1

Header Line 1
Header Line 2
NVN, NVP
for k=1 to NVP
for j=1 to NVN
k, j, SIGT(NHNN,NVNN)
end j loop
end k loop

IDEN = 2 or -2

Header Line 1
Header Line 2
NVN, NVP
for k=1 to NVP
for j=1 to NVN
k, j, SAL(k,j)
end j loop
end k loop

IDEN = 3 or -3

Header Line 1
Header Line 2
NVN, NVP
for k=1 to NVP
for j=1 to NVN
k, j, TEMP(k,j)
end j loop
end k loop

IDEN = 4 or -4

Header Line 1
Header Line 2
NVN, NVP
for k=1 to NVP
for j=1 to NVN
k, j, TEMP(k,j),SAL(k,j)
end j loop
end k loop

Note: j=1 at bottom, j=NVN at surface