--- Welcome to the official ADCIRCWiki site! The site is currently under construction, with limited information. ---
For general information, see the ADCIRC site, ADCIRC FAQ, or the ADCIRC Wikipedia page. For model documentation not yet available on the wiki, see the ADCIRC site. New content is being continuously added to the ADCIRCWiki, and material from the main ADCIRC site will be gradually transitioned over to the wiki.
Fort.11 file
(Redirected from Fort.11 file format)
Jump to navigation
Jump to search
The fort.11 file is only used for a baroclinic run. Baroclinic 2DDI runs are not yet supported. Baroclinic 3D runs occur if IDEN is not equal to 0.
File Format
The basic file structure is shown below. Each line of input data is represented by a line containing the input variable name(s). Blank lines are only to enhance readability. Loops indicate multiple lines of input.
File structure for a baroclinic 2DDI run
IDEN = 1 or -1
- Header Line 1
- Header Line 2
- NVP
- for k=1 to NVP
- end k loop
IDEN = 2 or -2
- Header Line 1
- Header Line 2
- NVP
- for k=1 to NVP
- 'jki,DASALT(jki)
- end k loop
IDEN = 3 or -3
- Header Line 1
- Header Line 2
- NVP
- for k=1 to NVP
- jki,DATEMP(jki)
- end k loop
IDEN = 4 or -4
- Header Line 1
- Header Line 2
- NVP
- for k=1 to NVP
- jki, DATEMP(jki), DASALT(jki)
- end k loop
File structure for a baroclinic 3D run
IDEN = 1 or -1
- Header Line 1
- Header Line 2
- NVN, NVP
- for k=1 to NVP
- for j=1 to NVN
- k, j, SIGT(NHNN,NVNN)
- end j loop
- for j=1 to NVN
- end k loop
IDEN = 2 or -2
- Header Line 1
- Header Line 2
- NVN, NVP
- for k=1 to NVP
- for j=1 to NVN
- k, j, SAL(k,j)
- end j loop
- for j=1 to NVN
- end k loop
IDEN = 3 or -3
- Header Line 1
- Header Line 2
- NVN, NVP
- for k=1 to NVP
- for j=1 to NVN
- k, j, TEMP(k,j)
- end j loop
- for j=1 to NVN
- end k loop
IDEN = 4 or -4
- Header Line 1
- Header Line 2
- NVN, NVP
- for k=1 to NVP
- for j=1 to NVN
- k, j, TEMP(k,j),SAL(k,j)
- end j loop
- for j=1 to NVN
- end k loop
Note: j=1 at bottom, j=NVN at surface