For general information, see the ADCIRC site, ADCIRC FAQ, or the ADCIRC Wikipedia page. For model documentation not yet available on the wiki, see the ADCIRC site. New content is being continuously added to the ADCIRCWiki, and material from the main ADCIRC site will be gradually transitioned over to the wiki.
This file contains the majority of the parameters required to run both the 2DDI and 3D versions of ADCIRC and the information to drive the model with harmonic boundary conditions (either elevation or flux). This file is required to run the ADCIRC model.
See fort.15 file format for details.
Tips and Tricks
By turning off all ocean state-related outputting and disabling wave coupling, ADCIRC will run in "met.-only" mode, a quick and convenient way to read in and write out meteorological data files. In this mode, only routines necessary for meteorological forcing are called, i.e. no water levels nor velocities are computed. Note that by changing
DT, you can speed up this "simulation". More specifically, since the only things being output are meteorological data, you can set
DT equal to the time interval you wish met. data to be output, and then set the
NSPOOLGW (the local and global met. output intervals) to
1 (i.e. output every time step). For typical 2D ADCIRC runs, this requires setting the following in the fort.15 file:
NOUTE = 0
NOUTV = 0
NOUTGE = 0
NOUTGV = 0
NHSTAR = 0
NHASE = 0
NHASV = 0
NHAGE = 0
NHAGV = 0
Ramping Meteorological Forcing at Hot-Start
Let's say you run a 15-day tide-only run and output a hotstart file. Then, you want to hotstart a simulation with meteorological forcing. Initiating the hotstart simulation with full-strength met. forcing could apply a shock to the system, creating spurious waves. Therefore, it's best to ramp in the met. forcing. But, ramping parameters like
DRAMP define the start of ramp time as being cold-start time. Setting
NRAMP = 8
means you can supply
DRAMPUnMete, which is the number of delays at which to start met. ramping, on the
DRAMP line. Here's an example:
5 0 0 0 0 0 0.5 0 15 ! DRAMP,DRAMPExtFlux,FluxSettlingTime,DRAMPIntFlux,DRAMPElev,DRAMPTip,DRAMPMete,DRAMPWRad,DRAMPUnMete
What this says is that a 0.5-day ramp will be applied to the met. forcing, starting at run day 15.0 (the hotstart simulation's start time).